Setting up
Your iPhone or iPad has to be on the same Wi-Fi network as the ventilation unit. A guest network, a separate IoT network, or a VPN will stop the app from reaching it.
- Open Settings inside the app.
- Enter the address of your unit, or tap Find on Network to check the current Wi-Fi network for a compatible controller.
- Tap Test Connection, then Save.
If you do not know the address, it is usually shown on the unit's own control panel under its communication or network menu, and your router's client list will also show it.
Contact
Please include your iPhone or iPad model, your iOS or iPadOS version, the make and model of your ventilation unit, and a short description of what happened. Do not send passwords or anything else sensitive.
Frequently asked questions
Which ventilation units are supported?
The app controls a heat-recovery ventilation unit that exposes a local HTTP interface. It has been developed and tested against a Utek Reversus EVO controller. Other units from the same OEM family may work. Units from other manufacturers most likely will not. Recuperation Controller is an independent app and is not affiliated with or endorsed by any ventilation manufacturer.
Can I try it before connecting a unit?
Yes. Turn on Demo mode in Settings, or tap Try demo on the first screen. Demo mode fills every screen with sample readings and makes no network requests, so you can see exactly what the app does before you go looking for your unit's address.
It says it cannot reach the device.
Check that your phone is on the same Wi-Fi network as the unit and not on a guest or IoT network, that a VPN is not running, and that the address in Settings is correct. Tap Test Connection to confirm. If the unit's address is handed out by DHCP it may have changed, in which case Find on Network will locate it again.
Why are fan RPM, fan hours, and season blank?
Those values are not exposed by the unit's HTTP interface, so the app marks them unavailable rather than showing a guess. Everything shown as a number is a real reading from your unit.
Can other people change the unit at the same time?
Yes, and the app expects it. It keeps following the unit while you have it open, so changes made from the wall panel or another phone show up. If you would rather freeze the values you are looking at, turn Live updates off in Settings.
How is the running cost calculated?
From the electricity price and maximum fan power you enter in Settings, applied to the current fan speed. It is an estimate for orientation, not a meter reading, and it does not know about your tariff's standing charges or time-of-day pricing.
How does filter tracking work?
Set your service interval in hours, then start filter tracking. The app counts fan runtime from that point and shows how much of the interval has been used. Start tracking again after you change the filter to reset the count.
Does it work away from home?
No. The app reaches your unit over your local network, so it works when your device is on that network. There is no cloud service to relay commands from elsewhere.
Does it sync between my devices?
No. Settings are stored on each device. Point each of your devices at the same unit address and they will all show the same live state, because the state lives on the unit rather than in the app.